It would be good for the community if this particular case was
tackled. More generically, I’ve seen a few requests about decoding captures
that have specific offsets, perhaps this something that needs to be tackled,
too.
Regards,
Frank
From:
wireshark-users-bounces@xxxxxxxxxxxxx
[mailto:wireshark-users-bounces@xxxxxxxxxxxxx] On Behalf Of Bill
Halvorsen (bhalvors)
Sent: Saturday, July 21, 2007 7:26 AM
To: wireshark-users@xxxxxxxxxxxxx
Subject: [Wireshark-users] Setting up a display offset
I
am using a feature called Cable Intercept on a Cisco CMTS, it packages up
traffic between two endpoints into a udp wrapper and sends it to a machin where
its collected using wireshark,
To
view the origianl packet I need to setup an offset of 58 bytes to view the
original IP packet.
