Wireshark-dev: Re: [Wireshark-dev] Help
From: Tyson Key <[email protected]>
Date: Wed, 12 Aug 2009 18:34:26 +0100
Hi, Divya.
You'll want to run ./wireshark in the directory that you've built it
in. It should then launch, if it was built fully.

Tyson.

On Wed, Aug 12, 2009 at 5:15 PM, divya
kothapally<[email protected]> wrote:
>
> Hello,
> Iam trying to launch wireshark by just doing a make on it. It is giving me
> following errors:
> gcc: sync_pipe_write.o: No such file or directory
> gcc: util.o: No such file or directory
> gcc: tap-rtp-common.o: No such file or directory
> gcc: capture_info.o: No such file or directory
> gcc: epan/.libs/libwireshark.so: No such file or directory
>
> Is there any way that i could launch the wireshark without doing a make
> install after make ?
> --
> Best,
> Divya Kothapally
>
> ___________________________________________________________________________
> Sent via:    Wireshark-dev mailing list <[email protected]>
> Archives:    http://www.wireshark.org/lists/wireshark-dev
> Unsubscribe: https://wireshark.org/mailman/options/wireshark-dev
>             mailto:[email protected]?subject=unsubscribe
>



-- 
Fight Internet Censorship! http://www.eff.org
               ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
http://i9.house404.co.uk/ | Twitter/FriendFeed/Skype: vmlemon | +447549728105