ANNOUNCEMENT: Live Wireshark University & Allegro Packets online APAC Wireshark Training Session
July 17th, 2024 | 10:00am-11:55am SGT (UTC+8) | Online

Ethereal-users: Re: [ethereal-users] Linux RedHat 6.2 - no TCP traffic?!

Note: This archive is from the project's previous web site, ethereal.com. This list is no longer active.

From: Dundo <dundo@xxxxxxxxxxxxxxxx>
Date: Mon, 22 May 2000 13:58:28 -0400
Yes, UDP address was different than laptop's IP address. All traffic that I've created was running between two other machines, not Ethereal machine itself. Regarding that hub.....that's definitely a hub.....it's an 'older' Cabletron Systems microMMAC-24E. SPARC machine is already connected to that same hub and I can monitor all traffic passing through using Ethereal on that station.

As you, I'm also suspicious about that PCMCIA NIC but I cannot figure out why it's not possible to 'see' only TCP. If this NIC is not able to run in promiscous mode I presume there would be no traffic visible at all. As I don't know anybody who has similar configuration I can' t compare configurations or make any additional test.

Regards,

Dundo


At 11:18 AM 5/22/00 -0500, Gilbert Ramirez wrote:
On Fri, May 19, 2000 at 05:03:52PM -0500, Dundo wrote:
>
>
>
> I've connected 'Ethereal' machine and two other machines to a hub just to
> be shure there's no switching problems. I've started Apache server and FTP
> server on one of these machines and then accessing them using another
> machine as a client I was trying to create some TCP traffic. None of these
> packets appeared. Then, I used nmap to create some TCP and UDP traffic and
> only UDP was visible. When I connect same 'Ethereal' machine to LAN (to be
> specific, Roving Analysis Port of 3COM router) I can see everything else
> except TCP.

Was the UDP to a unicast (non-broadcast, non-multicast) address that was
different than the laptop's NIC's IP address?

> It's very strange because I've already compiled Ethereal 0.8.8 on SPARC
> Solaris machine and everything runs perfectly. This machine that I have
> problems with is Gateway SOLO Notebook running RedHat 6.2 (Zoot) and it has
> 3COM Megahertz PCMCIA Ethernet adapter (Model 3CXFE575CT). I wanted to use
> this machine as a portable Network Analyzer.

What if you connect that SPARC machine to that hub. What does *it* see?

(I'm trying to figure out if it's the NIC in that laptop that won't go into
promiscous mode for some strange reason, or if the hub is really not a hub).

--gilbert


- Dundo -

--> This message has been sent on 100% recycled electrons <--