You have plug-in that implements the MEGACO protocol and using it you
can parse the MEGACO messages.
All you need to do is verify that Ethereal sees all plug-ins and if not
just go to plug-ins directory and run make install.
That should install all plug-ins to your Ethereal directory.
Restart the Ethereal, it will recognize your plug-ins and you will be
able to parse MEGACO messages.
Good luck
-----Original Message-----
From: ethereal-dev-bounces@xxxxxxxxxxxx
[mailto:ethereal-dev-bounces@xxxxxxxxxxxx] On Behalf Of Margarita Gayo
(TL/EEM)
Sent: Thursday, September 23, 2004 12:47 PM
To: 'ethereal-dev@xxxxxxxxxxxx'
Subject: [Ethereal-dev] H.248 Protocol over SCTP
Hello,
I have some H.248 traces, but I can only access to its M3UA Data in
hexadecimal format.
I have seen that martin.regner answered this question: "SCTP payload
protocol id needs to be 7 (H248) for it to work"
but, where should I set this to be able to see the MEGACO messages??
Thanks in advance,
Margarita
_______________________________________________
Ethereal-dev mailing list
Ethereal-dev@xxxxxxxxxxxx
http://www.ethereal.com/mailman/listinfo/ethereal-dev
