Now you will need to filter out the wifi management protocols in Wireshark, or you could do a filter on just TCP or UDP etc in Wire shark
P
Sent wirelessly from my BlackBerry device on the Bell network.
Envoyé sans fil par mon terminal mobile BlackBerry sur le réseau de Bell.
-----Original Message-----
From: Aaron Schneider <notstop@xxxxxxxx>
Sender: wireshark-users-bounces@xxxxxxxxxxxxx
Date: Tue, 12 Aug 2014 22:47:22
To: Community support list for Wireshark<wireshark-users@xxxxxxxxxxxxx>
Reply-To: Community support list for Wireshark <wireshark-users@xxxxxxxxxxxxx>
Subject: Re: [Wireshark-users] Use Wireshark to snif other computers on the
same wifi network
Hi:
Indeed I'm able to get monitor mode on the interface mon0, but now the protocol for all packets is 802.11. What's next?
> Hi;
>
> To verify if your network card can support monitor mode, you can do the
> following in KALI;
>
> #airmon-ng start wlan0 (or what ever you adapter is wlan1 etc)
>
> This should put your card in monitor mode if it supports it. Then do;
>
> #airmon-ng
>
> you should see wlan0 and mon0 as a listing of adapters.
>
> If you see mon0 then you know that the card is capable of monitor modem
> and use the mon0 adapter in Wireshark.
>
> Hope that helps.
>
> P
___________________________________________________________________________
Sent via: Wireshark-users mailing list <wireshark-users@xxxxxxxxxxxxx>
Archives: http://www.wireshark.org/lists/wireshark-users
Unsubscribe: https://wireshark.org/mailman/options/wireshark-users
mailto:wireshark-users-request@xxxxxxxxxxxxx?subject=unsubscribe
