That is a bit better, but the columns now show the hex value, not decimal,
as it did in V1.2.x where the filter used to be:-
ip.dscp.value
The problem seems to have crept in since the filter syntax was changed to:-
ip.dsfield.dscp
Keith French.
--------------------------------------------------
From: "Stig Bj�rlykke" <stig@xxxxxxxxxxxxx>
Sent: Wednesday, June 30, 2010 1:59 PM
To: "Community support list for Wireshark" <wireshark-users@xxxxxxxxxxxxx>
Subject: Re: [Wireshark-users] Adding DSCP column in Wireshark 1.4.0rc1
On Wed, Jun 30, 2010 at 2:45 PM, Keith French <keithfrench@xxxxxxxxxxxxx>
wrote:
I have just tried the development release Version 1.5.0-SVN-33383 and
that
is still the same as 1.4.0rc1, the columns for DSCP & 802.1P COS are
still
resolved & hence show the full verbose setting for each packet under the
column headers. It would be far more useful if this could be unresolved,
showing just the decimal value.
Did you try unselect "Show Resolved" in the column pop-up menu?
--
Stig Bj�rlykke
___________________________________________________________________________
Sent via: Wireshark-users mailing list <wireshark-users@xxxxxxxxxxxxx>
Archives: http://www.wireshark.org/lists/wireshark-users
Unsubscribe: https://wireshark.org/mailman/options/wireshark-users
mailto:wireshark-users-request@xxxxxxxxxxxxx?subject=unsubscribe
