Wireshark-users: Re: [Wireshark-users] display filter
Thanks.  That worked.

From: [email protected] [mailto:[email protected]] On Behalf Of Abhijit Bare
Sent: Tuesday, September 01, 2009 3:41 PM
To: Community support list for Wireshark
Subject: Re: [Wireshark-users] display filter

You can try a couple of methods:

1. Use editcap "-A" and "-B" option to create a new file with packets only between the two timestamps. Then, open the new file in wireshark.

2. You can use wireshark filter something like this:

frame.time > "Aug 20, 2008 01:34:13.000" and frame.time < "Aug 20, 2008 01:34:24.000"

Adjust the times according to what you want.

You can also filter on time relative to first frame using "frame.time_relative" if that is easier. Lookup "wireshark-filter" manpage.

Hope this helps,
- Abhijit

On Tue, Sep 1, 2009 at 1:20 PM, EDWARD HILL <[email protected]> wrote:
I have a capture file that I am working with and I only want to see the 10 minutes of data in the middle of the capture. So I want to create a display filter that would allow me to see all the traffic from 13:30 to 13:40. Can any one give me some ideas.

Sent via:    Wireshark-users mailing list <[email protected]>
Archives:    http://www.wireshark.org/lists/wireshark-users
Unsubscribe: https://wireshark.org/mailman/options/wireshark-users
            mailto:[email protected]?subject=unsubscribe