On Fri, Jul 10, 2009 at 3:49 AM, Chuck
Crisler<charles.crisler@xxxxxxxxxxx> wrote:
> Initially I downloaded, configured, built and installed
> the source. Then I used add/remove software (should have done that
> first!). I also loaded libpcap-14:0.9.8-f.fc10 (redhat) and
> libpcap-devel-14:0.9.8-3.fc10.
I suspect that your first problem was that you had no libpcap support
when building Wireshark. When you later ran configure you had
installed libpcap and libpcap-devel, and you found the devices in
Wireshark.
--
Stig Bjørlykke
