Hi,
That’s currently
not possible but if you do get the setup info in the trace I think it would
decode.
Regards
Anders
Från:
wireshark-users-bounces@xxxxxxxxxxxxx
[mailto:wireshark-users-bounces@xxxxxxxxxxxxx] För list mail
Skickat: den 21 januari 2008 18:52
Till: Community
support list for Wireshark
Ämne: Re: [Wireshark-users] How to
decode H264 ?
Hi Anders, thank you very much. I have got it for H264.
Another problem, for H263+, it's using the dynamic payload type
too, but I do not found it in Edit->prefrences->protocols.
How to decode the H263+ ?
2008/1/22, Anders Broman <anders.broman@xxxxxxxxxxxx>:
Hi,
H264 "decoding" (only minimal decoding is made), is only available
from WS 0.99.7 and
bugfixes has gon in since the release.(development builds available)
If you haven't got the setup information in your trace there is the option to
do
Edit->prefrences->protocols->h264 and set the Payload type 125 in your case. You still
have to
do decode as RTP every time you open the trace.
Regards
Anders
________________________________
From: wireshark-users-bounces@xxxxxxxxxxxxx
on behalf of list mail
Sent: Mon 1/21/2008 4:20 PM
To: wireshark-users@xxxxxxxxxxxxx
Subject: [Wireshark-users] How to decode H264 ?
Hi all, I'm new to Wireshark, it's a great software. Currently I using it to
analyse the H264 RTP video stream.
When I captured the H264 RTP video stream, and try to decodec it - use the
menu" Decodec As..." and choosed "RTP" to decode it,
but it just show me: "PT=Unknown (125), SSRC=0xD2D9EB2, Seq=35012,
Time=4266020486, Mark ",
So there have anybody can help me how to decodec it as H264 ?
Thank you in advance.
_______________________________________________
Wireshark-users mailing list
Wireshark-users@xxxxxxxxxxxxx
http://www.wireshark.org/mailman/listinfo/wireshark-users
