Hello,
It was possible to type over the interface name in the previous dialog with
the named pipe. This is described at
http://wiki.wireshark.org/CaptureSetup/Pipes ("3. The named pipe is not
listed in the drop-down interface selection, and must be typed into the
interface box. On Windows, it must be typed slowly (or pasted).").
Regards,
-COlin
-----Original Message-----
From: wireshark-dev-bounces@xxxxxxxxxxxxx
[mailto:wireshark-dev-bounces@xxxxxxxxxxxxx] On Behalf Of Michael Tüxen
Sent: August 10, 2011 5:33 PM
To: Developer support list for Wireshark
Subject: Re: [Wireshark-dev] Rev 38350 Capture Options Changes - Named Pipe?
On Aug 10, 2011, at 10:06 PM, Colin O'Flynn wrote:
> Hello,
>
> With the changes committed in rev 38350 which has a new capture options
dialog, how does one use a named pipe? I couldnt see a way to get this
working.
Use the command line options... There is currently no way to specify a named
pipe in the GUI. I think there was no way to do this in Wireshark 1.6, or
am I missing something?
Best regards
Michael
>
> Thanks,
>
> -Colin
>
___________________________________________________________________________
> Sent via: Wireshark-dev mailing list <wireshark-dev@xxxxxxxxxxxxx>
> Archives: http://www.wireshark.org/lists/wireshark-dev
> Unsubscribe: https://wireshark.org/mailman/options/wireshark-dev
> mailto:wireshark-dev-request@xxxxxxxxxxxxx?subject=unsubscribe
___________________________________________________________________________
Sent via: Wireshark-dev mailing list <wireshark-dev@xxxxxxxxxxxxx>
Archives: http://www.wireshark.org/lists/wireshark-dev
Unsubscribe: https://wireshark.org/mailman/options/wireshark-dev
mailto:wireshark-dev-request@xxxxxxxxxxxxx?subject=unsubscribe
