Huge thanks to our Platinum Members Endace and LiveAction,
and our Silver Member Veeam, for supporting the Wireshark Foundation and project.

Wireshark-dev: [Wireshark-dev] capture filter issue

Date: Mon, 19 Jul 2010 16:49:22 +0530

Hello,

 

When I am doing live capture with Wireshark using the “Capture filter” option (host 172.16.59.240), my expectation is that I can able to see both the to and from (source & dest) traffic with that ip address. But I can see only incoming traffic (i.e. destination ip address only), it is not showing any outgoing traffic from that ip address.

  

If I remove that filter and start capturing, then I can see both incoming and outgoing traffic with that ip address.

I am doubting some setup problem in my Wireshark, but not sure where to change.

Can you please help me on this issue.

 

Best regards,

Upendra

Please do not print this email unless it is absolutely necessary.

The information contained in this electronic message and any attachments to this message are intended for the exclusive use of the addressee(s) and may contain proprietary, confidential or privileged information. If you are not the intended recipient, you should not disseminate, distribute or copy this e-mail. Please notify the sender immediately and destroy all copies of this message and any attachments.

WARNING: Computer viruses can be transmitted via email. The recipient should check this email and any attachments for the presence of viruses. The company accepts no liability for any damage caused by any virus transmitted by this email.

www.wipro.com