-----Original Message-----
From: wireshark-bugs-bounces@xxxxxxxxxxxxx [mailto:wireshark-bugs-bounces@xxxxxxxxxxxxx] On Behalf Of bugzilla-daemon@xxxxxxxxxxxxx
Sent: den 23 juni 2010 16:11
To: wireshark-bugs@xxxxxxxxxxxxx
Subject: [Wireshark-bugs] [Bug 4902] Delta is always 0 in RTP Stream Analysis
https://bugs.wireshark.org/bugzilla/show_bug.cgi?id=4902
--- Comment #7 from Jaap Keuter <jaap.keuter@xxxxxxxxx> 2010-06-23 16:10:41 CEST --- (In reply to comment #6)
>> Ah okay - indeed the stream was from VLC and there was no way
>> wireshark could have known what the streams were. However, firstly
>> surly the delta column only requires the time at which the packets
>> were detected rather than any stream-specific information?
>
>I'm afraid not. The delta is based on the timestamps carried in the RTP packet, not the frame timestamps.
>
>> Having the arrival deltas in this column does make debugging and RTP
>> stream much easier even if the other columns can't be populated.
>
>Then you're not looking at the RTP timestamping but the capture timestamping.
>If you want to see that just change the Time Display Format from the View menu into Seconds since previous
>display packet.
>
>> Secondly, I've provided another sample file where again dynamic
>> payload types are used but the SIP/SDP is present and as such
>> wireshark is able to determine that the RTP streams are MP4V-ES and
>> speex respectively. In the case of the MP4V-ES stream wireshark does
>> populate all the columns but with the speex stream it does not,
>> despite knowing that the stream is speex. I assume it has just taken
>> the encoding name but is unable to read the RTP clock rate. It seems
>> like speex ought to be supported (and as I mention, in any case should have the delta column populated).
>
>Speex comes in several flavours, see RFC5574, and has three possible clock rates, see section 3.3: "The sampling >rate MUST be either 8000 Hz, 16000 Hz, or 32000 Hz." So, from Speex alone the clockrate can't be derived.
>
>What should be improved is the interpretation of the SDP negotiations, so these clock rates are extracted.
I think that's done in trunk already
/Anders
--
Configure bugmail: https://bugs.wireshark.org/bugzilla/userprefs.cgi?tab=email
------- You are receiving this mail because: ------- You are the assignee for the bug.
___________________________________________________________________________
Sent via: Wireshark-bugs mailing list <wireshark-bugs@xxxxxxxxxxxxx>
Archives: http://www.wireshark.org/lists/wireshark-bugs
Unsubscribe: https://wireshark.org/mailman/options/wireshark-bugs
mailto:wireshark-bugs-request@xxxxxxxxxxxxx?subject=unsubscribe
