Hi,
Once instance of Wireshark can only load one capture file at a time...
hence the behaviour you are seeing. If you want to load multiple
captures in one go, you will probably want to either use mergecap or
start multiple instances of WS.
HTH
Abhik
On Wed, Dec 17, 2008 at 10:40 AM, <atdev.queries@xxxxxxxxx> wrote:
> Hi all,
>
> When i tried to load the packets which i captured as
> $ wireshark -r packet1.pacp it has loaded me properly.
> But when i tried
> $ wireshark -r packet1.cap -r packet2.cap
> only second packet(packet2.cap) got loaded and not packet1.cap.
>
> Could any one please say me how to load two packets one after other using
> command line options.
> Please say me wheather we can load simultaneously one packet after the other
> using command line options.
>
> Thanks in advance,
>
> regards,
> Atdev.
>
> Please do not print this email unless it is absolutely necessary.
>
> The information contained in this electronic message and any attachments to
> this message are intended for the exclusive use of the addressee(s) and may
> contain proprietary, confidential or privileged information. If you are not
> the intended recipient, you should not disseminate, distribute or copy this
> e-mail. Please notify the sender immediately and destroy all copies of this
> message and any attachments.
>
> WARNING: Computer viruses can be transmitted via email. The recipient should
> check this email and any attachments for the presence of viruses. The
> company accepts no liability for any damage caused by any virus transmitted
> by this email.
>
> www.wipro.com
>
> ___________________________________________________________________________
> Sent via: Wireshark-dev mailing list <wireshark-dev@xxxxxxxxxxxxx>
> Archives: http://www.wireshark.org/lists/wireshark-dev
> Unsubscribe: https://wireshark.org/mailman/options/wireshark-dev
> mailto:wireshark-dev-request@xxxxxxxxxxxxx?subject=unsubscribe
>
