Yes, I've tried that, thanks.
Wireshark shows the packets as RTP but does not know the payload type.
I would like to make modifications to the source so that Wireshark
will understand the CODECs specified in the IOS5 signaling and
then subsequently call another dissector for RFC3558.
Thanks.
--
Michael Lum Principal Software Engineer
4600 Jacombs Road +1.604.276.0055
Richmond, B.C.
Canada V6V 3B1
Star Solutions
-----Original Message-----
From: wireshark-dev-bounces@xxxxxxxxxxxxx
[mailto:wireshark-dev-bounces@xxxxxxxxxxxxx] On Behalf Of Abhik Sarkar
Sent: November 15, 2008 1:53 AM
To: Developer support list for Wireshark
Subject: Re: [Wireshark-dev] How do you get RTP recognized by Wireshark
?
Hi Michael,
I don't know much about RTP, but I think I remember someone answering a
similar question recently... have you already trying turning on the
preference for RTP protocol called "Try to decode RTP outside of
conversations"?.
HTH
Abhik.
On Fri, Nov 14, 2008 at 10:06 PM, Michael Lum
<michael.lum@xxxxxxxxxxxxxxxxx> wrote:
> Hi,
>
> I have RTP streams that are set up with an unrecognized signaling
> protocol. I.e. not SIP/MGCP, etc.
>
> Can somebody give me a quick run down on what to change so that the
> streams can be recognized as RTP ?
>
> I thought all I might have to do was add a call to
> rtp_add_address() with the correct IP address, port, payload, etc.
> but it doesn't appear to work.
>
> Any help would be great.
>
> Thanks.
>
> --
> Michael Lum Principal Software Engineer
> 4600 Jacombs Road +1.604.276.0055
> Richmond, B.C.
> Canada V6V 3B1
> Star Solutions
> _______________________________________________
> Wireshark-dev mailing list
> Wireshark-dev@xxxxxxxxxxxxx
> https://wireshark.org/mailman/listinfo/wireshark-dev
>
_______________________________________________
Wireshark-dev mailing list
Wireshark-dev@xxxxxxxxxxxxx
https://wireshark.org/mailman/listinfo/wireshark-dev
