Wireshark-dev: Re: [Wireshark-dev] How do you get RTP recognized by Wireshark ?
From: "Abhik Sarkar" <[email protected]>
Date: Sat, 15 Nov 2008 10:53:26 +0100
Hi Michael,

I don't know much about RTP, but I think I remember someone answering
a similar question recently... have you already trying turning on the
preference for RTP protocol called "Try to decode RTP outside of


On Fri, Nov 14, 2008 at 10:06 PM, Michael Lum
<[email protected]> wrote:
> Hi,
> I have RTP streams that are set up with an unrecognized
> signaling protocol.  I.e. not SIP/MGCP, etc.
> Can somebody give me a quick run down on what to change
> so that the streams can be recognized as RTP ?
> I thought all I might have to do was add a call to
> rtp_add_address() with the correct IP address, port, payload, etc.
> but it doesn't appear to work.
> Any help would be great.
> Thanks.
> --
> Michael Lum                   Principal Software Engineer
> 4600 Jacombs Road             +1.604.276.0055
> Richmond, B.C.
> Canada V6V 3B1
> Star Solutions
> _______________________________________________
> Wireshark-dev mailing list
> [email protected]
> https://wireshark.org/mailman/listinfo/wireshark-dev