Huge thanks to our Platinum Members Endace and LiveAction,
and our Silver Member Veeam, for supporting the Wireshark Foundation and project.

Wireshark-dev: Re: [Wireshark-dev] Build Failure.Please help!!

From: Tobias Wärre <tobias.warre@xxxxxxxxxxxx>
Date: Tue, 10 Jun 2008 19:36:45 +0200
Hi
I'm not fully immersed of the details of the build process, but I think (well know, but I'm a bit modest... ;) ) it has to do with dependencies. The C:\wireshark-1.0.0\ folder and all subfolders except for those created during a build (to see the effect do a 'nmake -f Makefile.nmake distclean' and then a 'nmake -f Makefile.nmake all' and watch what folders that are created). In the end of the build, all necessary files are copied (using xcopy in windows) into /wireshark-gtk-1 and /wireshark-gtk2 and in those folders all dependencies are on the right places. The C:\wireshark-1.0.0\ is only a placeholder of the development files until the build is ready.

Was I fussy or (or perhaps even wrong) somewhere? If so, please say that.

Regards,
Tobias

-----Original Message-----
From: wireshark-dev-bounces@xxxxxxxxxxxxx [mailto:wireshark-dev-bounces@xxxxxxxxxxxxx] On Behalf Of Kumar, Hemant
Sent: den 10 juni 2008 18:42
To: Developer support list for Wireshark
Subject: Re: [Wireshark-dev] Build Failure.Please help!!

Hi

I am unable to launch wireshark.exe from C:\wireshark-1.0.0\ but able to successfully do it from C:\wireshark-1.0.0\wireshark-gtk1 Or C:\wireshark-1.0.0\wireshark-gtk2.


Thanks
Hemant

-----Original Message-----
From: wireshark-dev-bounces@xxxxxxxxxxxxx [mailto:wireshark-dev-bounces@xxxxxxxxxxxxx] On Behalf Of Stephen Fisher
Sent: Monday, June 09, 2008 9:16 PM
To: Developer support list for Wireshark
Subject: Re: [Wireshark-dev] Build Failure.Please help!!

On Fri, Jun 06, 2008 at 10:28:40AM -0700, Kumar, Hemant wrote:

> But now on launching the application it says that it is unable to 
> locate wiretap-0.3.1.dll though it is present in the following
> locations:--
>
> C:\wireshark-1.0.0\wiretap
> C:\wireshark-1.0.0\wireshark-gtk1
> C:\wireshark-1.0.0\wireshark-gtk2
>
> Can you please tell what I need to do to overcome this?

Are you launching wireshark.exe from the c:\wireshark-1.0.0\wireshark-gtk2\ (or -gtk1) folder?


Steve
_______________________________________________
Wireshark-dev mailing list
Wireshark-dev@xxxxxxxxxxxxx
https://wireshark.org/mailman/listinfo/wireshark-dev
_______________________________________________
Wireshark-dev mailing list
Wireshark-dev@xxxxxxxxxxxxx
https://wireshark.org/mailman/listinfo/wireshark-dev