Wireshark · Wireshark-dev: Re: [Wireshark-dev] local operation code in MAP

[<durgabhavani.uppuluru@xxxxxxxxx>]

Hi Anders,

 

Hex value shown, in the bytes pane is 99.

I’ve tried other numbers too (>150) and I get similar result.

 

Best Regards,

Bhavani.

 

From: "Anders Broman" <a.broman@xxxxxxxxx>
Date: Sun, 25 Feb 2007 19:55:43 +0100

Hi,

What is the hex value shown in the bytes pane when marking localvalue in the

middle pane?

Best regards

Anders

 

---

From: DurgaBhavani Uppuluru
Sent: Sunday, February 25, 2007 2:36 PM
To: 'wireshark-dev@xxxxxxxxxxxxx'
Subject: local operation code in MAP

 

Hi All,

 

Greetings to you.

 

I’m adding an operation with local value 153 to GSMMAP.

But dissector does not recognize 153, it reports Unknown -103.

Kindly tell me how to set this value.

 

Thanks,

Bhavani.

The information contained in this electronic message and any attachments to this message are intended for the exclusive use of the addressee(s) and may contain proprietary, confidential or privileged information. If you are not the intended recipient, you should not disseminate, distribute or copy this e-mail. Please notify the sender immediately and destroy all copies of this message and any attachments.

WARNING: Computer viruses can be transmitted via email. The recipient should check this email and any attachments for the presence of viruses. The company accepts no liability for any damage caused by any virus transmitted by this email.

www.wipro.com