https://bugs.wireshark.org/bugzilla/show_bug.cgi?id=7442
Summary: IO Graphs: Display Does Not Scroll Properly
Product: Wireshark
Version: 1.9.x (Experimental)
Platform: x86
OS/Version: Windows Vista
Status: NEW
Severity: Minor
Priority: Low
Component: Wireshark
AssignedTo: bugzilla-admin@xxxxxxxxxxxxx
ReportedBy: Jim@xxxxxxxxxxxxxxxxx
Created attachment 8734
--> https://bugs.wireshark.org/bugzilla/attachment.cgi?id=8734
Wireshark 1.6.8 IO graph. Display window not full, no horizontal scroll bar.
Build Information:
Version 1.9.0-SVN-43578 (SVN Rev 43578 from /trunk)
Copyright 1998-2012 Gerald Combs <gerald@xxxxxxxxxxxxx> and contributors.
This is free software; see the source for copying conditions. There is NO
warranty; not even for MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.
Compiled (32-bit) with GTK+ 2.24.10, with Cairo 1.10.2, with Pango 1.30.0, with
GLib 2.32.2, with WinPcap (4_1_2), with libz 1.2.5, without POSIX capabilities,
without libnl, with SMI 0.4.8, with c-ares 1.7.1, with Lua 5.1, without Python,
with GnuTLS 2.12.18, with Gcrypt 1.4.6, with MIT Kerberos, with GeoIP, with
PortAudio V19-devel (built Jul 5 2012), with AirPcap.
Running on 32-bit Windows Vista Service Pack 2, build 6002, with WinPcap
version
4.1.2 (packet.dll version 4.1.0.2001), based on libpcap version 1.0 branch
1_0_rel0b (20091008), GnuTLS 2.12.18, Gcrypt 1.4.6, with AirPcap 4.1.1 build
1838.
Built using Microsoft Visual C++ 10.0 build 40219
--
In Wireshark 1.6.8, when IO Graphs is selected during a live capture, the
display scrolls continuously from right to left so that one can always see the
traffic currently being captured and no horizontal scroll bar is visible until
the traffic has scrolled all the way from the right edge to the left edge and
can no longer all be displayed at once in the display window.
In Wireshark 1.9.0-SVN-43578 the display does not scroll properly. If IO Graphs
is selected immediately after the live capture is started, only the first few
seconds of the capture are visible in the display window. A horizontal scroll
bar pops up immediately, and the only way to see the traffic currently being
captured is to keep pulling the scroll bar to the right manually.
Three screenshots are attached.
1. The first shows IO Graphs in Wireshark 1.6.8. The display has scrolled
almost, but not quite, to the left edge. There is no horizontal scroll bar
visible.
2. The second is also 1.6.8. In this one, the display has reached the left
edge. The horizontal scroll bar is now visible, but the IO graph display
continues to scroll from right to left so that traffic currently being captured
is always visible at the right side of the graph.
3. The third one is version 1.9.0-SVN-43578. The capture has been running for
15 seconds, but the display is not scrolling and less than 5 seconds of traffic
is visible in the display window.
This behavior is also seen in Wireshark 1.8.0.
--
Configure bugmail: https://bugs.wireshark.org/bugzilla/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are watching all bug changes.
