https://bugs.wireshark.org/bugzilla/show_bug.cgi?id=6560
--- Comment #2 from Maynard <wireshark@xxxxxxxxxxxxxxxx> 2011-11-14 14:52:47 PST ---
Created an attachment (id=7418)
--> (https://bugs.wireshark.org/bugzilla/attachment.cgi?id=7418)
PCAP showing WireShark errors with routing headers
(I think the attached file shows the problems. Its been a few days since I
went through the calculations, but I believe the file shows the problems)
If you look at frame #6, it has a routing header, but the segments left is 0.
The final L3 destination address is in the L3 header, not the routing header.
Frame 9 shows the same problem. Frame 10 is calculated correctly as the
segments left is non-zero.
Frame 3 shows an IPv4 frame with a routing header where wireshark also
calculates the wrong checksum.
I believe all frames in this file have the correct checksums calculated.
--
Configure bugmail: https://bugs.wireshark.org/bugzilla/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are watching all bug changes.
