Wireshark-bugs: [Wireshark-bugs] [Bug 5515] The MAC of a switch which appears in captures doesn'
Date: Wed, 22 Dec 2010 12:55:33 -0800 (PST)
https://bugs.wireshark.org/bugzilla/show_bug.cgi?id=5515

Sake <[email protected]> changed:

           What    |Removed                     |Added
----------------------------------------------------------------------------
             Status|NEW                         |RESOLVED
         Resolution|                            |INVALID

--- Comment #1 from Sake <[email protected]> 2010-12-22 12:55:32 PST ---
You can best ask your reseller or the Telemecanique support channel for
assistance. Wireshark shows the mac-addresses as they are seen on the wire. You
can check this also by looking at the arp-table of a directly connected device.
Ping the switch first and then do a 'arp -an'.

Just a tip: many Layer3 devices own a whole range of mac-addresses as they may
need mac-addresses for many purposes. This might be the case here as well.

Closing as INVALID as this is not a Wireshark problem.

-- 
Configure bugmail: https://bugs.wireshark.org/bugzilla/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are the assignee for the bug.