https://bugs.wireshark.org/bugzilla/show_bug.cgi?id=4271
Summary: No traffic generated by a Cisco Pagent router is
captured and/or shown.
Product: Wireshark
Version: 1.2.4
Platform: x86
OS/Version: Windows 7
Status: NEW
Severity: Normal
Priority: Low
Component: Wireshark
AssignedTo: wireshark-bugs@xxxxxxxxxxxxx
ReportedBy: M.Komon@xxxxxxxxxxxxxx
Build Information:
Version 1.2.4 (SVN Rev 30978)
Compiled with GTK+ 2.16.2, with GLib 2.20.3, with WinPcap (version unknown),
with libz 1.2.3, without POSIX capabilities, with libpcre 7.0, with SMI 0.4.8,
with c-ares 1.6.0, with Lua 5.1, with GnuTLS 2.8.1, with Gcrypt 1.4.4, with MIT
Kerberos, with GeoIP, with PortAudio V19-devel (built Nov 16 2009), with
AirPcap.
Running on 32-bit Windows 7, build 7600, with WinPcap version 4.1.1 (packet.dll
version 4.1.0.1753), based on libpcap version 1.0 branch 1_0_rel0b (20091008),
GnuTLS 2.8.1, Gcrypt 1.4.4, without AirPcap, from the PortableApps U3 device
in
drive D:.
Built using Microsoft Visual C++ 9.0 build 30729
--
No traffic generated by a Cisco Pagent router is captured and/or shown.
I tried to capture test traffic generated by a Cisco 4500 router with Pagent
IOS. Firstly I run a SPAN session on a Cisco Catalyst 2950 switch and I could
see in interface counters that the traffic was being copied to the sniff port.
However WS showed no such traffic.
I also connected directly to the router (cross-over cable, could see CDP
packets etc) and run a capture but no test traffic was captured.
Tested this with 1.2.3 and 1.2.4 under Windows 7 with the same results. Also
tested with to me unknown version of WS under WinXP. The router is a Cisco 4500
with ethernet 10Mbit half-duplex interfaces.
I will be glad to help if I can, feel free to contact me for more info about
the issue.
--
Configure bugmail: https://bugs.wireshark.org/bugzilla/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are the assignee for the bug.
