https://bugs.wireshark.org/bugzilla/show_bug.cgi?id=6996
Anders Broman <anders.broman@xxxxxxxxxxxx> changed:
What |Removed |Added
----------------------------------------------------------------------------
Status|NEW |RESOLVED
Resolution| |FIXED
--- Comment #1 from Anders Broman <anders.broman@xxxxxxxxxxxx> 2012-04-01 02:25:02 PDT ---
A fix committed revision 41876. I'll mark this for backporting to 1.6.x
The H263 dissector needed at least 4 bytes to look for a PSC.
As for the validity of the stream
-- RFC 2190 --
5.1 Mode A
In this mode, an H.263 bitstream will be packetized on a GOB boundary
or a picture boundary. Mode A packets always start with the H.263
picture start code [4] or a GOB, but do not necessarily contain
complete GOBs. Four bytes are used for the mode A H.263 payload
header. The H.263 payload header definition for mode A is shown as
follows with F=0. Mode A packets are allowed to start at a GOB
boundary even if no GOB header is present in the bitstream for the
GOB. However, such use is discouraged due to the dependencies it
^^^^^^^^^^^^^^^^^^^^^^^
creates across GOB boundaries, as described in Section 3.3.
--- RFC 2190 ---
One would expect a GOB header at the start of the data and sending so
few bytes in an RTP packet seem very inefficient.
--
Configure bugmail: https://bugs.wireshark.org/bugzilla/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are watching all bug changes.
